No products in the cart.
WURTH WEB SPRAY HI-TEMP CONTACT ADHESIVE 500ml
R795,00
Shipping will temporarily be billed separately and after we receive your order.
WURTH WEB SPRAY HI-TEMP CONTACT ADHESIVE 500ml
A high performance contact adhesive with a unique resin formula which creates a tough and resilient bond line between decorative surface materials and all common wood substrates.
Description
- Fast Drying
- High Temp Resistance – 128°C
- High Solids
- Portable Systems
- Easy Application Control
- Class 1 Fire Rating
- BS 6222 Bond Strength Approval
Notice
NOT RECOMMENDED for use with plasticised vinyls, flexible plastics, expanded/extruded polystyrene, PE or PP
- Use only in well ventilated areas.
- DO NOT thin or reactivate with solvents.
- DO NOT incinerate.
- DO NOT expose to extreme heat over 50°C.
- Keep away from sources of ignition.
- Release pressure before disconnecting hose.
- Test for suitability before use.
Application area
Suitable for bonding High-Pressure Laminate, Glass Reinforced Plastic (or Fiberglass) and Aluminium to a wide variety of substrates including Medium-Density Fibre board, Chipboard, Plywood and many other timber sheet materials and is designed for permanent bonding where immediate bond strength and high heat resistance are required.
Wurth Web spray hi-temp contact adhesive can also be used for bonding sheet metals, where surface preparation is very important – surface must be degreased and lightly abraded with fine abrasive or non-woven material.
Instructions
- This product is designed to be applied to two surfaces to be bonded together. Make sure that surfaces are clean, dry and free from dirt, dust, oil, loose paint, wax or grease, etc. For best results, the temperature of the adhesive and the surfaces being bonded should be between60ºF – 80ºF (16ºC – 27ºC).
- Use with adequate ventilation. When possible we recommend shaking the canister well before using. Attach and secure hose tightly onto the spray gun with required tip. Attach the other end of the hose onto the canister. Make sure the hose-valve connections are securely tight. Open the valve on the canister slowly and fully, check for leaks during this process. Unlock the trigger on the spray gun to start spraying.
- Prior to use, check compatibility by spraying a small test patch of the adhesive on the substrate. This product may degrade some substrates. Spray about 10-20 cm (4”– 8”) away at a 90º angle to the surface, applying a uniform, even coat of adhesive to obtain 80% to 100%coverage of the surface. If necessary, spray another coat of adhesive in areas that appear to need more adhesive. Spray both surfaces to be bonded, one surface vertically and the other surface horizontally. Allow the adhesive to tack off until no adhesive transfers to the knuckle when touched.
- Adhere surfaces and press together with adequate pressure. A roller is recommended to apply a uniform pressure to achieve maximum strength. Allow 24 hours for the adhesive to fully cure.
- If the spray tip clogs, unscrew the spray tip from the gun and clean with solvent such as lacquer thinner or acetone. Do not use a pin on the spray tip orifice.
Please note that shipping will be quoted and invoiced separately after online order.
Related products
WURTH WEB SPRAY HI-TEMP CONTAC... R795,00